Cable Gland Stripping Length: Where to Cut the Jacket
Strip to the insert seat, not to a copied number. How jacket strip length is set by gland design and cable construction, and the three failures a wrong cut causes.
قراءة المزيدStrip to the insert seat, not to a copied number. How jacket strip length is set by gland design and cable construction, and the three failures a wrong cut causes.
قراءة المزيدSpanner size is the width across flats, not the thread size. Full M14-M63 and PG7-PG63 charts with cut-out diameter, thread length and the body/locknut hex split.
قراءة المزيدPG25 clamps 15 to 22 mm cable on a 32 mm thread. Its dimensions match M32 exactly, so the real decision is shielding, and that is where the EMC version earns its place.
قراءة المزيدA PG19 gland clamps 10 to 14 mm cable on a 25 mm thread, and six of its seven dimensions are identical to M25. What actually decides between them.
قراءة المزيدPG21 clamps 13 to 18 mm cable through a 28.3 to 28.5 mm hole, and its real competitor sits 0.3 mm away at M28. Why “PG21 vs M20” is the wrong question, and why the hole rather than the cable decides this size.
قراءة المزيدM14 is the smallest metric cable gland we make, and the only one whose 7 mm thread is shorter than the locknut stack it has to pass through. Here are the five numbers, the 4 to 8 mm band it shares with M16, and why M16 is usually the better buy when the hole is new.
قراءة المزيد