The gland is only as good as the hole it sits in. How wall material, thread length, locknuts, knockouts and gland plates decide whether an enclosure stays at its stated IP rating.
Seguir leyendo
A combiner box is a density problem: too many entries, too little spanner room, and a thin moulded wall. How to schedule, space and seal the entries before anything is drilled.
Seguir leyendo
A PV cable entry has to survive twenty-five years of sun and thermal cycling with no maintenance access. What that changes about cable sizing, UV stability, material choice and entry geometry.
Seguir leyendo
A cable gland contains two elastomer seals, and they are not always the same compound. Here is how EPDM, NBR and silicone actually differ, where each one fails, and what to put in an enquiry.
Seguir leyendo
A leaking cable gland is rarely a faulty gland. Read the water to find which of the four entry routes it used, match the symptom to the interface that failed, and fix the cause instead of replacing the part again.
Seguir leyendo
Earthing and bonding do different jobs. The three return paths a gland can provide, the seven interfaces that break continuity, and how to test them on site.
Seguir leyendo
